Parts -
Default values
- Margins - setting margin values for parts will cause the optimization
engine to consider the part Length = Length + Left margin + Right margin
and Width = Width + Top margin + Bottom margin.
Every new part added manually will have its margin values set to the
default margin values.
- Edge banding - specifies the default band type for
each side of the part. Every new part added manually will have its edge
banding info set to the default edge banding values. Empty value means
edge banding is disabled for that side of the part.
- Works - specifies the default value of works for
parts. Every new part added manually will have its works value set to
the default works value.
The parts default values can be applied to the parts in the current job
as well. To apply the parts default values to all parts in the current
job click the "Apply default values..." button from the parts
section and check the default values you would like to apply, as illustrated
in the picture below:
Then click "OK". The selected default values will be applied
to all parts in the current job.
|